mfforever Posted March 22 Posted March 22 Hi all .....thought I had finally finished my Goodman Magnum K rebuild ......... screwed in the 16 screws into the back and hooked it up ..... put on a song and ....... NOTHING ! Not a sound ........ did a continuity check with my multimeter ...... NOTHING. Obviously I made a mistake when translating the cross over schematics. ...... have included the schematics, a picture of my cross over and a drawing of what I did. Desperate to finish this project as I am so close after so long ....... would really appreciate any advice or suggestions ........ Cheers.
Martykt Posted March 22 Posted March 22 @mfforever this would be a neater way to design your crossover with the corrections to make it work. All negative terminals on your drivers go to your common negative terminal. 1
mfforever Posted March 23 Author Posted March 23 Did exactly as you advised and ALL IS FANTASTIC IN AUDIOLAND AGAIN !!!!!! Thankyou Spinspin69, acg and Martykt for those knowledgeable eyes ........ and Martykt, I will do the second crossover with your above diagram as it is a very elegant solution....... I am most impressed with the sound coming through the one speaker....... bass and mid very smooth and clear whilst the brand new Scanspeak tweeter will ( after some burn in ) be a big step up over the 60 year old original ) Will post final sound review after second speaker completed and all run in ...... can see the full progress of this project on this forum under " rebuilding Goodmans Magnum K speakers " You have got to love this Audio Community ........ allows you to get things done when your skills in some areas are very average to say the least. 3
Recommended Posts