Jump to content

Usher factory build.


Recommended Posts



1 hour ago, cazzesman said:

 

Fascinating.

 

Regards Cazzesman

 

Saw it by accident on YouTube, came up as a suggestion 

Had a pair of Ushers, wish they were still available in Australia 

  • Like 2
Link to comment
Share on other sites

Essentially good build quality but some aspects are quite basic.Like using a stroke sander which are pretty crude and dusty devices .I do wonder how often they sand through the veneer layer which would mean throwing that cabinet out.Also using rotary sanders without dust extraction.The dust in there would be pretty horrible.And somebody needs to buy some rubber mallets!

Edited by THOMO
Link to comment
Share on other sites



The scene of laying up the sheets of veneer brings back memories of a job I once had in a plywood factory, except I had to lay sheets bigger than 8' X 4' single handedly. The inner layers weren't too bad at about 2.5mm thick, but I ripped a few of the face sheets that were only about 1.5mm thick.

 

And yes, the soldering in that clip was pretty dodgy..

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.




×
×
  • Create New...
To Top