Jump to content

2010 NEW PRODUCT ARRIVAL- AER DISC & ENVIRONMENT ENERGIZER


Recommended Posts

[glow=yellow,2,300][shadow=purple,left]AER DISC ENERGIZER[/shadow][/glow]

 

[move][shadow=orange,left][glow=orange,2,300]Listed Price@ $840.00/unit. Promo Price@ $699.00/unit[/glow][/shadow][/move]

 

 

 

TECHNICAL INTRODUCTION

 

In traditional electro-acoustic engineering, people only focus on the physics of the frequency spectrum from 20Hz to 20kHz, commonly known as "audible spectrum". If that is the only frequency range that matters, all audio cables & speaker wires should sound the same, all brands of tubes should sound almost the same, all amplifiers IC's should sound almost the same. However, almost every audiophile had experienced the noticeable difference in performance between cables, tubes, amplifiers and so on. Why?

 

The reason is that there is a lot of harmonics in musical signal besides the fundamental frequencies. More importantly, these are very precious details in high fidelity reproduction. Eg. when the drumstick hits the bass drum (very low frequency instrument), the leading edge(very sharp rise of amplitude in very short time) signal created by the quick touch can be up to the kilohertz range. In the case of piano,the last key can produce a fundamental frequency of 4186Hz but the eighth harmonic of the same key is actually 33488Hz. Moreover, when the pianist hits the key, the leading edge can have even much higher frequency content which our ears can sense. Anyone can find out this fact by comparing the sound of the same piece of music from a real piano & the sound of a normal hi-fi system that can only work up to 20kHz. The real piano should sound more dynamic with a wider range of frequency response.

 

Since music harmonics can be up to very frequencies (well over 20kHz), the electrical characteristics of components at very high frequency will affect the music reproduction. In many expensive professional audio equipment, it is common to see the presence of non-indusive capacitors, ultra high speed IC's and so on. The reason for the factory to spend that extraordinary high cost in producing the equipment is to make sure that it sounds great. In many cases, expensive components may not always sound good due to the fact that the "micro phase alignment" (phase alignment of signal or particle motions uinder very high frequency condition) was not taken care of. This problem is indeed more obvious in video equipment design as the signal frequency is much higher. After over 25 years of scientific research, we now have a perfect solution to recover all those valuable details of audio and video signals.

 

Thanks to the proprietary Euphoria Technology, the AER Disc Energizer can indue the "micro phase alignment field" to a CD or DVD effectively within 5 seconds (through photon emission)simply by pressing a button. Once the disc has the induced energy and being excited by the laser of the player, two things will happen. On one hand, the disc will produce a micro phase alignment field that aligns all the signal paths (conductor in audio equipment) closed (within 1m) to the disc player. On the other hand, the disc will generate a micro phase alignment field that aligns the motions (sound wave in air) of gases and water molecules in the air. Once the micro phase alignment is achieved, signal loss in equipment and energy loss of sound wave (music details) in air particles will be minimized. It is also very easy to notice that the bass will be stronger, deeper and with more details due to less micro phase cancellation in the sound transmission. The result is higher density of midrange, wider and taller sound stage, solid extension of bass and treble, more energetic vocals and wider dyamic range.

 

Besides, the Disc Engergizer is also very effective for Cables,room environment,equipment upgrading. The improvement will be more impressive when the resolution of the source is higher, particularly for Blue Ray DVD and HD DVD. In video performance, movies will look more 3 dimensional with revealing colors; graphics will be more solid, material texture will be more detail. Needless to say, the sound will be more exciting. You will discover that your whole equipment setup is more enjoyable than you thought.

 

AER works on the following items:

 

1.  Equipments like CD players, DAC, Amps, Pre-amps, anything that runs in current!

2.  Disc Medias like Blu-rays, DVD, CD, even your VCD.

3.  Environment- rooms acoustics

4.  Cables, speakers etc.

 

On demo now@

 

MUSICLINK AV DISTRIBUTION

100 BEACH ROAD, #02-46-49

SHAW TOWER

TEL:62911106

BUSINESS HOURS: Mon-Sat:12.30-8PM daily.

                        Sun & Public Holiday:Closed.[/glow]

Link to comment
Share on other sites



  • 2 weeks later...

[glow=yellow,2,300][shadow=purple,left]AER DISC ENERGIZER[/shadow][/glow]

 

[move][shadow=orange,left][glow=orange,2,300]Listed Price@ $840.00/unit. Promo Price@ $699.00/unit[/glow][/shadow][/move]

 

 

 

TECHNICAL INTRODUCTION

 

In traditional electro-acoustic engineering, people only focus on the physics of the frequency spectrum from 20Hz to 20kHz, commonly known as "audible spectrum". If that is the only frequency range that matters, all audio cables & speaker wires should sound the same, all brands of tubes should sound almost the same, all amplifiers IC's should sound almost the same. However, almost every audiophile had experienced the noticeable difference in performance between cables, tubes, amplifiers and so on. Why?

 

The reason is that there is a lot of harmonics in musical signal besides the fundamental frequencies. More importantly, these are very precious details in high fidelity reproduction. Eg. when the drumstick hits the bass drum (very low frequency instrument), the leading edge(very sharp rise of amplitude in very short time) signal created by the quick touch can be up to the kilohertz range. In the case of piano,the last key can produce a fundamental frequency of 4186Hz but the eighth harmonic of the same key is actually 33488Hz. Moreover, when the pianist hits the key, the leading edge can have even much higher frequency content which our ears can sense. Anyone can find out this fact by comparing the sound of the same piece of music from a real piano & the sound of a normal hi-fi system that can only work up to 20kHz. The real piano should sound more dynamic with a wider range of frequency response.

 

Since music harmonics can be up to very frequencies (well over 20kHz), the electrical characteristics of components at very high frequency will affect the music reproduction. In many expensive professional audio equipment, it is common to see the presence of non-indusive capacitors, ultra high speed IC's and so on. The reason for the factory to spend that extraordinary high cost in producing the equipment is to make sure that it sounds great. In many cases, expensive components may not always sound good due to the fact that the "micro phase alignment" (phase alignment of signal or particle motions uinder very high frequency condition) was not taken care of. This problem is indeed more obvious in video equipment design as the signal frequency is much higher. After over 25 years of scientific research, we now have a perfect solution to recover all those valuable details of audio and video signals.

 

Thanks to the proprietary Euphoria Technology, the AER Disc Energizer can indue the "micro phase alignment field" to a CD or DVD effectively within 5 seconds (through photon emission)simply by pressing a button. Once the disc has the induced energy and being excited by the laser of the player, two things will happen. On one hand, the disc will produce a micro phase alignment field that aligns all the signal paths (conductor in audio equipment) closed (within 1m) to the disc player. On the other hand, the disc will generate a micro phase alignment field that aligns the motions (sound wave in air) of gases and water molecules in the air. Once the micro phase alignment is achieved, signal loss in equipment and energy loss of sound wave (music details) in air particles will be minimized. It is also very easy to notice that the bass will be stronger, deeper and with more details due to less micro phase cancellation in the sound transmission. The result is higher density of midrange, wider and taller sound stage, solid extension of bass and treble, more energetic vocals and wider dyamic range.

 

Besides, the Disc Engergizer is also very effective for Cables,room environment,equipment upgrading. The improvement will be more impressive when the resolution of the source is higher, particularly for Blue Ray DVD and HD DVD. In video performance, movies will look more 3 dimensional with revealing colors; graphics will be more solid, material texture will be more detail. Needless to say, the sound will be more exciting. You will discover that your whole equipment setup is more enjoyable than you thought.

 

On demo now@

 

MUSICLINK AV DISTRIBUTION

100 BEACH ROAD, #02-46-49

SHAW TOWER

TEL:62911106

BUSINESS HOURS: Mon-Sat:12.30-8PM daily.

                         Sun & Public Holiday:Closed.[/glow]

Link to comment
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...


Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...
To Top