Jump to content

Diva repair and support needed


Recommended Posts

Hi, I brought the Diva amp from TS Lim longtime ago.Now 1 of the resistor is

burn and I need to know the value of the resistor.see attach location.My

version use 6SL7WGT(2) and 6SN7GTB(2) tube.The resistor is between 2 capacitor

150uf and the power supply is for the 2 6SN7 tube. I hope you can help.thanks

note: I try to contact T.S.Lim but still no reply.

 

Link to comment
Share on other sites



seems like a RC circuit to block dc signal. if possible go back to him or any repair shop like Adrian. or just solder some value resistor across it 1K Ohms. btw, what did you do that cause it to burn

When I switch on, I noticed spark and burn. I open up and notice resistor burn. I check other parts ,look ok. What cause the burn, no idea.

thanks

Link to comment
Share on other sites

Try to contact T.S. again. I just corresponded with him before the new year. He can give your amp a thorough check up to make sure everything else is fine at the same time.

Do you have his email address? I sms him, still no reply.

Link to comment
Share on other sites



Do you have his email address? I sms him, still no reply.

 

nowadays he always travel to China to show his skills there. He is even a forum moderator of a very active diy tubeamp forum with most members from china. perhaps he is in china now. like what watchdog says, better to let him check. and since now the resistor is burnt , no values can be deciphered. hence, ts lim is the only one to know the value.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...
To Top