Hi guys,

 

Got a Creative 2.1 speaker system from a friend today.

 

Tested good except that 1 of the spker rca connector when touch will cost sound loss.

 

Did sound testing and confirm that is probably a wire at the rca connector could be partially O C.

 

So thinking of repairing with a rca connector after trimming of the end.

 

Problem : do not see any polarity indicator on the wires..

 

So is it alright to solder either end to the center pin of the RCA connector???

 

thanks in advance

All have polarity of course.

Try one way if it is out of phase, then you redo, lah

wah,

 

so "leh chet" ...

 

ok thanks

 

will hav to wait when have more time...

 

In the old times there was often access to one of the wires at the centre of the membrane, so polarity could be checked.

I doubt this is easily accessible to you

In the old times there was often access to one of the wires at the centre of the membrane, so polarity could be checked.

I doubt this is easily accessible to you

 

yup,

practically inaccessible so asking...how to test..

Problem with this satelite spkrs, wire so thin, want to change oso difficult

got much yield meh, i mean afterall its just an MM speaker...how much do you want outta it even if you could change the polarity.

got much yield meh, i mean afterall its just an MM speaker...how much do you want outta it even if you could change the polarity.

 

no much  ;D ;D ;D but at least the sound will not disappeared when listening thro the pc.