Jump to content

Only the channel 9 channels viewable


Recommended Posts

Ok, long story shirt.

2 TVs in the house.

One received all channels and the other only all the channel 9 variants.

They both use the same aerials.

ive tried to retune it but still no luck.

any ideas?

Link to post
Share on other sites

Either Coax is damaged to 1 point, or length of cable run may require an amp to get sufficient signal strength to tune. Is the 1 only getting 9 further from the aerial?

Link to post
Share on other sites
11 minutes ago, blybo said:

Either Coax is damaged to 1 point, or length of cable run may require an amp to get sufficient signal strength to tune. Is the 1 only getting 9 further from the aerial?

Yes it’s further from the aerial but it been working perfectly for years up until a week or 2 ago.

Link to post
Share on other sites
3 minutes ago, Yamaha_man said:

Yes it’s further from the aerial but it been working perfectly for years up until a week or 2 ago.

Could be storm damage to the splitter or 1 of the joins. Coax joins will deteriate over time, especially exposed to the elements. My aerial is inside my roof space so never gets wet or blown around.

 

Suggest you get an aerial guy in. Perhaps try another portable TV to that point first to and see if could be the TV's tuner at fault.

Edited by blybo
Link to post
Share on other sites

1 minute ago, Yamaha_man said:

Yes it’s further from the aerial but it been working perfectly for years up until a week or 2 ago.

Have you taken it into the same room as the no problem tv and connected it to the aerial there? If the problem persists, it's likely the tv. If the problem is solved, then you may need to have the aerial cable replaced.

  • Like 2
Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.



×
×
  • Create New...