Jump to content

Mixing speaker impedances


nzlowie

Recommended Posts

Now I have my mid range xover sorted I'm going to add the tweeter section. The mid driver is 16 ohm, should I get a 16 ohm tweeter to match or not worry as the xover component values will be calculated on the actual driver value? (No parallel caps on this one....)

Link to comment
Share on other sites



2 minutes ago, davewantsmoore said:

There's no need to match the nominal impedance of the drivers ....  as long as the crossover filters you design work the way you want them to with the driver impedances and sensitivities you have

Agreed.

 

The only thing to note is when thinking of what your "nominal impedance" is with respect to what amplifier to match it to, pick the lowest impedance your crossover gets down to.

Edited by Ittaku
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.




×
×
  • Create New...
To Top