Jump to content

ProjectX, FusionHDTV and teletext


Recommended Posts

Hi,

Has anyone gotten ProjectX to extract teletext out of FusionHDTV created .tp files? I've tried different options (out->[x]Teletext, subtitle->[801],(x)free) in ProjectX but I always only get the m2v and mp2/ac3 files.

ProjectX does however hint on the existance of teletext in the files I'm using:

Teletext:	PIDs: 0x2A(eng_s801 )
Teletext:	PIDs: 0x240(eng_s801 )
Teletext:	PIDs: 0x404(eng_s801 eng_i100 )

Link to comment
Share on other sites



I'm using ProjectX 0.81.8.01 (JRE 1.4.2_5), Fusion 3.0beta1, Fusion DTB-T Lite, single subchannel recording, and not doing any filtering.

I was extracting teletext subtitles last night out of a FusionHDTV stream.

Any chance you could post the full contents (warning: big) of your X.ini file?

Thanks.

Link to comment
Share on other sites

I'm using ProjectX 0.81.8.01 (JRE 1.4.2_5), Fusion 3.0beta1, Fusion DTB-T Lite, single subchannel recording, and not doing any filtering.

I have a similar set up. The same version of ProjectX, a slightly earlier JVM, and running the 2.70.02 drivers. I was capturing the transport stream off SBS last night.

Any chance you could post the full contents (warning: big) of your X.ini file?

I've PMed you the X.ini file I have. Good luck!

Link to comment
Share on other sites



  • Recently Browsing   0 members

    • No registered users viewing this page.




×
×
  • Create New...
To Top