New Sensations Posted April 5, 2016 Share Posted April 5, 2016 Item: Schiit Mjolnir 2 headphone amplifier w/ LISSTLocation: Camperdown, NSWPrice: AU$1250 + postageItem Condition: 9.5/10 Would suit 'new' buyer.Reason for selling: Reviewed Payment Method: Pickup - Cash, COD OnlyExtra Info: Schiit's fully balanced input and output headphone amp and/or pre-amplifier. For serious head-fi-ers and active speakerers looking for the best of both worlds: the Mjolnir 2 can be run solid state or with tubes. Purchased last November from A2A. The store price on the amp is AU$1649 and the LISST 'tubes' are another AU$169. Total = AU$1818. Here however is a chance to skip out on several hundred scheets and save. That might not be enough for some of you who want to feel like you've got even more of a bargain. You can make an offer via PM but go too low and I'll just ignore ya. I think that's fair. This unit was used until Dec 14th and has been in storage since. Schiips with all original packaging and store receipt. Wait. Tube or solid-state? Yes. Not only is Mjolnir 2 the only balanced tube hybrid headphone amp, it introduces our all-new LISST solid-state tube option for a 100% solid-state option. In terms of performance, it is a unique end-game headphone amp fully ready for any headphone, from IEMs to the hardest-to-drive planars.5-Year Warranty.Mjolnir is covered by a limited warranty that covers parts and labor for five years. That’s 5 years. Yes. FIVE. Compare that to the competition. Made in USA—ReallyDon’t roll your eyes. When we say, “Made in USA,†that’s exactly what we mean, with no weasel-wording. The vast majority of the total cost of Mjolnir goes to US companies manufacturing in the USA—most of them within easy driving distance from our office.Choose Tube Hybrid, Solid-State, or BothYes, that’s right. You can get Mjolnir 2 as a tube hybrid, or as a pure solid-state amp—or get both, and swap out as you’d like. You can also swap the standard 6BZ7 tubes for anything in the 6DJ8, 6922, ECC88, and 2492 families, to “roll†the sound to your specific preference. Or just opt for the Schiit LISST (Linear, Integral Solid-State Tube) for a 100% solid state amp. Power and Control in AbundanceMjolnir 2 puts out up to 8W/channel into 32 ohms, but is fully ready for high-sensitivity headphones with switchable gain. Use the standard gain of 8 for hard-to-drive headphones, or switch to a gain of 1 for sensitive on-ear models and IEMs. In addition, Mjolnir 2 also offers both balanced and single-ended input, switchable via the front panel. Want more? How about both balanced and single-ended headphone outputs and balanced and single-ended preamp outputs. Mjolnir also makes a great preamp for your power amps or powered monitors.Pure Balanced, Differential TopologyMjolnir uses our exclusive, inherently balanced and differential Crossfet topology—the only circlotron-style topology in a headphone amplifier (well, except for Ragnarok.) It’s balanced in and balanced out, with a custom 4-gang RK27 Alps volume pot—providing end-game performance for a mid-level price.Frequency Response: 20Hz-20Khz, -0.1db, 2Hz-400KHz, -3dBMaximum Power, 32 ohms: 8.0W RMS per channelMaximum Power, 50 ohms: 5.0W RMS per channelMaximum Power, 300 ohms: 850mW RMS per channelMaximum Power, 600 ohms: 425mW RMS per channelTHD: <0.005%, 20Hz-20KHz, at 1V RMSIMD: <0.006%, CCIF?, at 1V RMSSNR: >104db, unweighted, referenced to 1V RMS, in low gain modeCrosstalk: >-75dB, 20 Hz-20KHzOutput Impedance: 1 ohm ?(high gain), 0.3 ohms (low gain)Gain: 8 (18dB) or 1(0db), via front-panel switchTopology: Tube voltage gain or solid-state tube voltage gain, cross-shunt push-pull Crossfet output stage, noninverting, single voltage gain stagePower Supply: specific Circlotron 4-secondary output stage transformer with over 65,000uF filter capacitance, plus dedicated transformer for high-voltage discrete-regulated front end stage with 200V rails and over 4,000uf of filter capacitanceInputs: one pair balanced XLR, one pair single-ended RCAs, switchable via front panel switchOutputs: one 4-pin balanced female XLR, one ¼†TRS phono, one pair 3-pin male XLR preamp, one pair single-ended RCAPower Consumption: 45W Size: 16 x 8.75 x 2.25†Weight: 13 lbs Pictures: Link to comment Share on other sites More sharing options...
john.reekie Posted April 5, 2016 Share Posted April 5, 2016 Hi John, the warranty is transferrable? (With A2A I mean.) Link to comment Share on other sites More sharing options...
petec Posted April 5, 2016 Share Posted April 5, 2016 Hi, no remote on this is there? Link to comment Share on other sites More sharing options...
New Sensations Posted April 6, 2016 Author Share Posted April 6, 2016 S O L D. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts